"RUBY" P1 Phono Amplifier with Seperate Power Supply

Ruby Amp and Power Supply front veiwRuby Power Supply front veiwRuby Power Supply rear veiw

The RUBY P1 is a two-channel phono preamplifier module with very accurate RIAA equalization and many features. It is realized with the best semiconductors available and non-inductive, low noise, SMD metal film resistors. The circuit is designed to accept both moving coil (MC) and moving magnet (MM) transducers/cartridges directly in order to eliminate the need for an external MC step-up transformer or amplifier. MC/MM input loading, gain and input capacitance values are easy to select with high resolution DIP switches.

The Module is ideal for the most demanding applications requiring accurate RIAA equalization, very low noise, extremely low distortion and superior sonic performance.

The RUBY P-1 module has been custom-built for Wyetech Labs by completely automated state of the art assembly methods using extremely precision components with tolerances to 0.1% accuracy.

Wyetech Labs has employed dual completely independent plus and minus power supplies for each channel rendering the most accurate level attainable by any means. [far outperforms battery supply operation]

SHUNT REGULATION IN DC POWER SUPPLY

The Niagara river produces enormous power while still allowing some water to flow over the falls to maintain the beauty of it and allow it to be a world attraction. It only consumes a portion of the water flow to meet these dual requirements.

It is the equivalent to Shunt Regulation in audio power supplies and specifically in the Ruby Phono power supply.

The power supply is designed to produce more power than what is actually needed while the surplus power is dissipated as heat in order to maintain a precise voltage to the amplifier itself. The amplifier drains the current [ power ] from the power supply as needed which can vary depending on the signal output, while fixating the VOLTAGE to a precise level to eliminate any modulation of the actual audio voltage signal.

The dual RED / GREEN LED's show the operation of these four circuits. The LED's monitor this excess current which flows through each of them such that they become the status of the proper operation. They should always be lit but the intensity of the light output could vary depending on the AC voltage fed to it. Low AC input voltage can cause the LED's to turn off. The green LED will shut down first then the red if the AC voltage continues to sag further. Even if this happens you will not find any deterioration in sound because the +/- 26 volt DC output is further reduced to +/- 16 volts by an onboard regulator on the analog PCB module. Notwithstanding in proper operation they should always be lit up if your input AC is operating at the proper AC voltage.

In other words the amplifying circuit is always supplied with the power it needs which can vary with the signal while the excess power is dissipated through the ground as heat. This type of regulation is called shunt regulation and is considered to be far superior to a series type regulator which is why we chose to implement it in this product.

Secondary DC regulators on the analog module further reduce the voltage to +/- 16 volts for each channel from the +/- 26 volts feeding it. This double regulation further reduces any possibility of noise or distortion in the analog module.

FEATURES

TECHNICAL SPECIFICATIONS

DC ELECTRICAL CHARACTERISTICS

AC ELECTRICAL CHARACTERISTICS